Loading...
HomeMy WebLinkAbout0216_211211 RESOLUTION APPROVING "BLOCK 'F', SOUTH SAN GABRIEL UTIMAN RENEWAL ADDITION" BE IT RESOLVED BY TIIE CITY COUNCIL OF GEORGlTOIN. , TEXAS:• That the Urban Renewal Agency of the City of Georgetown, Texas owner of that certain tract of land designated as "Block 'F', South San Gabriel Urban Renewal Addition" to the City of Georgetown, Texas, is hereby authorized to file for record in the office of the County Clerk of Williamson County, the Map or Plat of said tract attached hereto, and the said County Clerk of Williamson County is hereby authorized to accept for filing and to record said Map of said Tract of land. ADOPTED AND APPROVID this 10 day of August, 1970. ATTLST: Jay C. Sloan, Layor, City of Georgetown City Secretary M 0 V AN AMMME T TO TETE PLUMBING CODE OF THE CITY OF GEORGETOUNI , TEXAS, AMENDING CHAPTETt 12 BY ADDING A NEIV SECTION, 12.1.3.1; AMENDING SECTION 12.1.4 AND AMENDING CHAPTETt 22, SECTION 22.2.2 BE IT ORDAINED that the Plumbing Code of the City of Georgetownr Texas, en- acted October 14, 1963, is hereby amended as follows: Section 1. of this amendment Chapter 12 of said Plumbing Code, "MATERIALS - QUALITY AND WEIGIIT" is hereby amended by adding thereto the following: "12.1.3.1 Nothwithstanding anything in said Plumbing Code it is Pereby provided that plastic pipe and fittings may be installed as hereinafter provided andlsuch pipe and fittings shall be approved by the City Council acting by and through its plumbing inspector. Such plastic pipe may be used for drain, waste, vents, building and/or house sewers, indirect waste and storm drains, throughout all types of buildings. Such pipe shall be schedule 40 ABS or PVC, MVV as specified in Commercial Standard 270-65 or 272-65. Pipe and fittings shall be identified as provided in the above. Standard and shall bear the seal of the National Sanitation Foundation. Pipe for storm drains and indirect wastes will meet the requirements of CS 207-60 for PVC or CS 218-59 for ABS," All plastic pipe and fittings shall be marked as follows: Manufacturer's Name PVC -1 -Schedule 40 -CS -272 -65 -NSF -DIV Fittings PVC-I-NSF-DWV ABS Schedule 40-CS-27O-65-NSF-Dlti'V ABS Fittings 40-CS-270-65wN1SF-DWV Markings shall be visible for inspection on both Pipe and Fittings of PVC and ABS All underground piping within buildings shall be imbedded in six (6) inches of sand below, above, and to both sides of the pipe. The Plumbing Inspector of the City of Georgetown may determine at any time if additional protection is necessary. Such pipe materials shall be used in accordance with manufacturers' recommended practices and procedures, but in no case shall they be less restrictive than as outlined in Commercial Standard 272-65-270-65 or the recommendations of the National Sanitation Foundation Standards. Provisions of the expansion and support of the pipe shall be as recommended by these standards."